Миниатюризация микрополосковых СВЧ-устройств
Аннотация
Данная работа посвящена миниатюризации квадратурных и кольцевых мостовых устройств. Описана процедура проектирования миниатюрных конструкций, основанная на замене отрезка микрополосковой линии передачи на фильтр нижних частот, обладающий таким же фазовым сдвигом, что и заменяемый отрезок. Проведено моделирование предлагаемых конструкций и получены их частотные характеристики. Изготовлены опытные образцы, и измерены их характеристики, которые подтверждают работоспособность устройства.
Abstract
This work is dedicated to the miniaturization of the quadrature ring and bridge devices. The procedure of designing miniature structures based on replacement of a segment of microstrip transmission line on a low-pass filter, which has the same phase shift that model and cut. The simulation of the proposed designs and obtained their frequency characteristics. Built prototypes of, and measured their characteristics, which confirm the efficiency of the device.
Abstract
This work is dedicated to the miniaturization of the quadrature ring and bridge devices. The procedure of designing miniature structures based on replacement of a segment of microstrip transmission line on a low-pass filter, which has the same phase shift that model and cut. The simulation of the proposed designs and obtained their frequency characteristics. Built prototypes of, and measured their characteristics, which confirm the efficiency of the device.